DIN9766941的部落格

. Place the grounding screw near the foot of the motor and use it securely. The distance is about 0. The fastening bolt is used to press the motor shaft.Both ends of the shaft are engraved with a reference line. Note: Vibration motor outlet cable is wearing parts, often due to vibration and friction damage, leading to motor phase lossCoal GasifierGas Equipment,Coal Gas Equipment,Industrial Coal Gas EquipmentTang Shan Jin Zhi Science .

The outer surface of the lower eccentric block is provided with a scale Anchor Bolts Suppliers for indicating the rotation angle. Unscrew both sides of the eccentric block compression bolts, the two sides of the eccentric block rotates in the same direction, so that the inner eccentric block on the excitation force scale score aligned with the outer eccentric block on the slit, adjusted to the required excitation force, Note: In addition to special applications, the position of the eccentric block at both ends of the vibration motor shaft must be corresponding, the percentage of the eccentric block at both ends must be set equal, otherwise vibration motor will produce Huge wrong excitation force, damage motor vibration machinery.9 meters.. Four-core cable grounding wire, one end of the junction box with the ground screw connected to the Other end must be grounded. Small vibration motor, there is no junction box on the case, the use of heavy three-core cable directly from the motor wiring.

Unscrew both sides of the outer eccentric block compaction bolts, both sides of the outer eccentric block rotates in the same direction so that the shaft alignment outer eccentric block on the excitation force scale engraved lines, adjusted to the required excitation force, tighten the outer eccentric (3) vibration motor greater than or equal to MV50-2, MV50-4, MV50-6, MV30-8 of the vibration motor (including these four specifications), the outer eccentric block is fixed Block, with key fixed on the shaft, can not rotate. The two ends of the shaft are engraved with a reference line.6 meters to 0. Loosen the lower eccentric block and tighten the bolt, and turn the lower eccentric block so that the angle scale on the lower eccentric block is aligned with the reference mark of the rotary shaft Line, adjusted to the desired angle, tighten the lower Eccentric compression bolts; To adjust the angle of the eccentric block can also be adjusted accordingly.

Connect the power Vibration motor out of the cable to withstand vibration, so should be used heavy four-core cable, near the cable outlet is not allowed to suddenly bend, to have a greater than the cable diameter 8-9 times the bending radius, and then the cable Secure to a stationary machine or frame. 2, vertical vibration motor: (1) the excitation force adjustment: remove the additional block compression bolts, by increasing or decreasing the number of additional blocks to adjust the excitation force; (2) the upper and lower eccentric block angle adjustment: The eccentric block is a fixed block, the lower eccentric block is adjustable block, are fastened with bolts fastening the motor shaft. The inner eccentric block is an adjustable block, and the outer surface is equipped with a scale that indicates the percentage of the maximum excitation force. In the fixed cable clamp should be padded with a soft insulating material, so as not to damage the cable friction